Ford Skorpio +1.1. Identification of the car +2. Maintenance + 3. Motors - 4. System cooling 4.1. Technical characteristic +4.2. Unloading of liquid and stuffing of the system of cooling 4.3. Removal and installation of an electric heater 4.4. Removal and installation of the thermostat +4.5. Supporter 4.6. Cooling of bomb of system 4.7. Temperature sensor 4.8. Driving of belt of the motor DOHC 4.9. Mechanism of a tension of a belt of driving +5. Fuel system +6. Union +7. Transmissions +8. Driving axle and rear bridge +9. Direction +10. Supports of the triangular form of interruption +11. Brakes system +12. Wheels and tires +13. Body +14. Electric equipment
|
MOTORS OF OHC
Bomb of the system of cooling and thermostat of the motor OHC
|
1 - case of thermostat,
2 - placing,
3 - ring fighter,
4 - thermostat,
5 - spring clip,
6 - krylchatka of the bomb,
7 - placing,
8 - load,
9 - I marry,
10 - pulley nave |
ORDER OF REALIZATION |
1. For desconectar they connect a weight of the accumulator. |
2. To fuse the system of cooling. |
|
3. Desconectar to hose better of the case of thermostat in the advanced party of a head of the cylinder block. |
4. To unscrew pins and to withdraw the case of the thermostat and placing. |
|
|
5. A spring clip to catch the screwdriver (the drawing in the left) the thermostat and to take the thermostat together with a ring of fighter (the drawing on the right). |
6. To compensate for the inter-connected surfaces of the case of the thermostat and a head of the cylinder block. |
|
7. The installation is done in the sequence of the return to the removal, at the same time the arrow (it is shown by an arrow) a current of the thermostat has to go to the motor. |
8. To begin and to heat the motor, and also to check the tension of connections of the system of cooling. |
9. After cooling of the motor to check and in case of the necessity of adding the level of cooling the liquid in a wide tank. |
|
MOTORS OF DOHC
ORDER OF REALIZATION |
1. For desconectar they connect a weight of the accumulator. |
2. To fuse the system of cooling. |
3. For the improvement of the access to the thermostat in motors with the system of the injection of the fuel to weaken collars and to catch the telephone that joins the camera of the elevated pressure and a collector of entry. |
|
2. To fuse the system of cooling. |
4. Desconectar hoses of cooling the liquid of the case of thermostat. |
|
5. To call - of the capture of the switch of the supporter of the cooling installed in case of thermostat. |
|
6. To unscrew three pins and to withdraw the case of thermostat. |
|
7. The installation is done in the sequence of the return to the removal, at the same time the valve of security of the thermostat has to be installed (it is shown by an arrow). |
|
MOTORS OF V6
The thermostat is withdrawn in the course of the removal of the water bomb. |
|