FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+ 3. Motors
- 4. System cooling
   4.1. Technical characteristic
   +4.2. Unloading of liquid and stuffing of the system of cooling
   4.3. Removal and installation of an electric heater
   4.4. Removal and installation of the thermostat
   +4.5. Supporter
   4.6. Cooling of bomb of system
   4.7. Temperature sensor
   4.8. Driving of belt of the motor DOHC
   4.9. Mechanism of a tension of a belt of driving
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

4.7. Temperature sensor

GENERAL INFORMATION

The sensor of temperature of motor OHC (the collector retires)

Motor of DOHC agreement of sensor of temperature

The sensor of temperature of motor DOHC (it is specified by an arrow) is located in the advanced party of a collector of entry.

For the OHC and models DOHC the agreement of the sensor of the temperature of the motor is shown in drawings.

In the models V6 the sensor is located below of the superior connection of a hose in the advanced left side of a head of the cylinder block.

ORDER OF REALIZATION

1. To take away the pressure in the system of cooling so that it will unscrew a cork of a wide tank.

2. To withdraw the capture of the sensor. To unscrew and to withdraw the sensor.

3. The installation is done in the sequence of the return to the removal. Before crushing of the sensor to apply the selante in a sensor woodcarving.