FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+ 9. Direction
- 10. Supports of the triangular form of interruption
   -10.1. Dispatch the support of the triangular form of interruption
      10.1.1. Technical characteristic
      -10.1.2. Service and repair
         10.1.2.1. Ray of an advanced support of the triangular form of interruption
         10.1.2.2. Removal and installation of a torture of an advanced support of the triangular form of interruption
         10.1.2.3. To be demolished and meeting of a torture of a support of the triangular form of interruption
         10.1.2.4. Removal and installation of the stabilizer
         10.1.2.5. Substitution of the capture metalrubber of the lever
         10.1.2.6. Removal and installation of a rotary fist
         10.1.2.7. Installation of advanced wheels
         10.1.2.8. Substitution of loads of wheel
   +10.2. Support of the triangular form of subsequent interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

10.1.2.5. Substitution of the capture metalrubber of the lever

ORDER OF REALIZATION

1. To withdraw the lever of support of the triangular form of interruption.

2. To unscrew a nut of a pin of the fixation of the lever to a crossbeam of amount of motor.

3. To withdraw the quiff and to unscrew a nut koronchaty of the spherical hinge of the lever of a rotary fist and to pinch had gone to spherical hinge of the lever of a rotary fist through an artist of streaptise.

4. To unscrew a nut of the fixation of the stabilizer to the lever and to withdraw an advanced metal lavador and the capture of metalrubber advanced.

5. Desconectar and to take the angry lever.

6. To arrange in a vice-adaptation 14.027 to take the capture of metalrubber, the lever of a support of the triangular form of interruption and the corresponding auxiliary capture.

7. Pinching had been the capture of metalrubber of the lever.

8. The new capture to dip metalrubber of the hinge of the lever into the soap water and to put this capture, adaptation and the auxiliary capture in a vice.

9. To hold tight the metalrubber they tie an opening of lever of support of the triangular form of interruption.

10. To insert the lever in a crossbeam of a support of the triangular form of interruption and for the aim of the stabilizer. To install the capture of metalrubber advanced and an advanced metal lavador; to hold tight the corresponding moment a nut of the fixation of the stabilizer to the lever.

11. To insert the spherical hinge of the lever in a rotary fist, to hold tight a nut koronchaty the corresponding moment and to register it the quiff.

Prevention

If after the corresponding moment will corset itself of a nut koronchaty it is impossible to insert the quiff, then it is necessary to keep on corseting of a nut in such a corner that will allow an insertion of quiff (it is impossible to unscrew a nut koronchaty).

12. To insert a pin of the fixation of the lever to a crossbeam of an amount of motor and the armband to put new самоконтрящуюся, without holding tight it.

13. After lowering of the car to hold tight a nut of a pin of the fixation of the lever to a crossbeam of amount of motor.