Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+ 9. Direction
- 10. Supports of the triangular form of interruption
-10.1. Dispatch the support of the triangular form of interruption
10.1.1. Technical characteristic
-10.1.2. Service and repair
10.1.2.1. Ray of an advanced support of the triangular form of interruption
10.1.2.2. Removal and installation of a torture of an advanced support of the triangular form of interruption
10.1.2.3. To be demolished and meeting of a torture of a support of the triangular form of interruption
10.1.2.4. Removal and installation of the stabilizer
10.1.2.5. Substitution of the capture metalrubber of the lever
10.1.2.6. Removal and installation of a rotary fist
10.1.2.7. Installation of advanced wheels
10.1.2.8. Substitution of loads of wheel
+10.2. Support of the triangular form of subsequent interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment
|
Desmontagem
| ORDER OF REALIZATION |
| 1. To withdraw a torture of support of the triangular form of interruption. |
| 2. There insists the lowest part of a torture of a support of the triangular form of interruption on a vice. |
| 3. 14.021 to install the device for the spring compression and to hold tight a spring of support of the triangular form of interruption. |
| 4. To unscrew a nut of the fixation of the basic placing of a torture of a support of the triangular form of interruption, when there is blockading a stick of absorbent one of the shock a key of nests of six 6 mm sides. |
| 5. To take the basic placing, the basic load, the superior basic springs of plate, a covering of rubber, and also the spring pressed together with the adaptation. |
| 6. To withdraw the buffer of rubber of a stick of absorbent one of the shock. |
| 7. To check a condition of details and the purity of basic plates of one spring. |
|
Meeting
| ORDER OF REALIZATION |
| To join a torture of support of the triangular form of interruption, executing operations in the return sequence regarding the removal process. To pay attention to the correct installation of one spring in basic plates. |
|
ABSORBENT OF THE SHOCK
The absorbent of the defective shock can be determined by the next signs:
– swinging of the car in the moment of movement along the way with asperezas periodic;
– not damp oscillations of a body in the moment of movement along the unequal way;
– strong inclinations of the car in dispersal and frenagem;
– blows existence in the moment of the movement of the car;
– insufficient union of a wheel of the car, specially in turns.
The control of a condition of the absorbent one of the shock happens in the bookcase, nevertheless approximately the condition of the absorbent one of the shock can be defined, stretching out and holding tight a stick of absorbent one of the shock. At the same time the effort in the whole length of the course of a stick of the absorbent one of the shock will be uniform and identic, without strange noises. |
|
