FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+ 9. Direction
- 10. Supports of the triangular form of interruption
   +10.1. Dispatch the support of the triangular form of interruption
   -10.2. Support of the triangular form of subsequent interruption
      10.2.1. Technical characteristic
      +10.2.2. Service and repair
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

10.2. Support of the triangular form of subsequent interruption

10.2.1. Technical characteristic

GENERAL INFORMATION

Support of the triangular form of independent subsequent interruption, in the trekhplechy the inclined levers were joined fundamentally to a ray of a rear axle, the springs of screw and the telescopic absorbent ones of the shock of the bilateral action located in springs of support of the triangular form of interruption.

Depending on the version of a support of the triangular form of interruption (standard or strengthened) the absorbent ones of the shock have different characteristics.

Absorbent of the shock

It marks – Ford Motorcraft.

Installation of rear wheels

Wheels convergence – 0,3 ± 3,25 mm.

Naves of rear wheels

Each nave is established in two conical loads.

The agreement happens holding tight of a nut of a nave of a wheel the corresponding moment.

Springs

The springs of screw are located in front of absorbent of the shock.

Quantity of circles of work of one spring	4
Diameter of a wire of one spring:
– GL, model of CL	12,05 mm
– the GL, model of CL with the hydraulic auxiliary direction rocket	12,15 mm
– the model of Ghia and GL with motors with system of injection of fuel	12,25 mm

Moments pressure

Lever of support of the triangular form of interruption	80 - 95 nanômetros
Ray of a rear axle	68,5 - 88 nanômetros
The case of the back launches a bridge to a ray of a rear axle	70 - 90 nanômetros
Nave of a rear wheel	250 - 290 nanômetros
Nut of fixation of a wheel	100 nanômetros