FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car



Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+ 8. Driving axle and rear bridge
- 9. Direction
   9.1. Technical characteristic
   +9.2. Service and repair
   -9.3. Direction with the hydraulic auxiliary rocket
      9.3.1. Technical characteristic
      -9.3.2. Service and repair
         9.3.2.1. Removal and installation of directing the transfer
         9.3.2.2. To be demolished and meeting of directing the transfer of the GEAR OF CAME
         9.3.2.3. To be demolished and meeting of directing the transfer of ZF
         9.3.2.4. Removal and installation of a column of direction
         9.3.2.5. To be demolished and meeting of a column of direction
         9.3.2.6. Removal and installation of the bomb of the amplifier of direction
         9.3.2.7. To be demolished and meeting of the bomb of the hydraulic auxiliary rocket
         9.3.2.8. Substitution and agreement of a tension of a belt of driving
         9.3.2.9. Substitution of protective coverings of the mechanism of direction
         9.3.2.10. Removal of air of system of direction with the hydraulic auxiliary rocket
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment


bfe6b27a


9.3.2.8. Substitution and agreement of a tension of a belt of driving

ORDER OF REALIZATION
1. To withdraw a weight they connect of the accumulator.
2. In cars with the condicionador to withdraw a belt of compressor of driving.
3. In cars with motors OHC to weaken pins of a level of agreement of a tension of a belt of the creator.
4. In cars with motors V6 to weaken a pin of the fixation and a pin at a level of agreement of the bomb. To turn the bomb to the motor and to take away a belt of driving.
5. To check a condition of a belt of driving of existence of slits, stratification and other mechanical damages and if necessary it will substitute. In case of what two driving belts are established, both belts are subject to the substitution even if one of belts will be in good form.
6. The agreement of a tension of a belt is done alternatively from the creator or bomb of the motor and his fixation in this pressure of situation of pins at an agreement level. The tension of a belt will be such that holding tight a belt with the moderated effort the deflexão of a belt did 10 mm.