FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+ 2. Maintenance
- 3. Motors
   +3.1. Motor of OHC
   -3.2. Motor of DOHC
      3.2.1. Technical characteristic
      +3.2.2. The repair that does not demand the removal of the motor
      +3.2.3. Removal and installation of the motor without transmission
      3.2.4. System of ventilation of a case
      -3.2.5. Lubrication system
         3.2.5.1. Removal and installation of a case of oil
         3.2.5.2. Removal and installation of the bomb of oil
         3.2.5.3. Desmontagem of the bomb of oil
   +3.3. Motor of V6
   +3.4. Systems of ignition and management of motor
   +3.5. Diesel engines
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

3.2.5.2. Removal and installation of the bomb of oil

GENERAL INFORMATION

Oil bomb

1 - asterisk of the bomb of oil,
2 - oil bomb,
3 - placing,
4 - covering of the bomb of oil,
5 - valve reduction,

6 - rotor,
7 - bomb accommodation,
8 - placing,
9 - oil receiver

To unscrew of a pin of the device of tension of a chain of driving of the bomb of oil of the motor DOHC

ORDER OF REALIZATION

1. To withdraw a weight they connect of the accumulator.
2. To take away a creator they direct the belt.
3. To weaken a pin of the fixation of a pulley of an end of inclination. For an exception of a provorachivaniye of an end of inclination unscrewing a pulley it is necessary to register a pendulum of teeths of a gear garland or to include the fifth transfer and in the spectator to hold tight against the stop a brake of foot.
4. For the access improvement to withdraw an electric heater as it is difficult to withdraw a pulley of an end of inclination in the established electric heater.
5. In motors with the system of the injection of the fuel to withdraw a hose of the ventilation of a case, the accumulative camera and the case of the filter of air.
6. To unscrew partially a pin of the fixation of a pulley of an end of inclination and, using an artist of streaptise, to withdraw a pulley. The captures of an artist of streaptise will rest against a metal part of a pulley.
7. To unscrew 11 pins of the fixation and to withdraw the lowest covering of the mechanism that distributes the gas. To withdraw the consolidation of rubber.
8. To unscrew a pin and to withdraw a natyazhitel of a chain of the walk of the bomb of oil.
9. To unscrew a pin of the fixation of an asterisk in the oil bomb and to withdraw an asterisk together with a chain.
	10. To unscrew 4 pins (they are specified by firearms) and to take the bomb of oil of the cylinder block.

Installation

ORDER OF REALIZATION

1. To compensate carefully for the inter-connected surfaces of the cylinder block and the bomb of oil.

2. To fill out the oil of motor in the bomb, to install the new placing in the bomb, to install in the cylinder block and to screw pins of fixation, having held tight them the necessary moment.

3. The new operations are done in the sequence of the return to the removal.