FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

13.4.9. Removal and installation of bedcovers of bumpers

MODELS TO THE WAY OF 1990 (ALL THE MODELS, EXCEPT GHIA)

ORDER OF REALIZATION

1. To withdraw bumpers.

2. To separate an old mistake of bumpers.

3. To clean the glue remains of a flute of a mistake in bumpers. To wash out an alcohol of metilo of flute and to dry it.

4. To devote itself with a fine and uniform layer in a flute they glue the ground and to allow to him to dry. The ground is handed together with a new mistake.

5. To heat lightly a new mistake. Less than 300 mm do not move a mistake in rings with a diameter.

6. To withdraw a protective movie of a mistake. To insert the edge of a mistake in a groove in one of the ends of a flute of a bedcover in bumpers of the 10 mm depth. A mistake to insist on a flute, advancing bumpers, and it will insert another end in a groove in another end of bumpers.

Prevention

Not to cut a mistake as his faces of end they are sealed of the moisture penetration.

7. To establish bumpers.

THE MODELS GHIA AND ALL THE MODELS OF THE WAY OF 1990

The differences in the moment of removal and installation of mistakes are composed in the next one:

– except the glue the mistake fixes nuts in hair hair clips;
– the insulating tape for necklace of a mistake is handed separately of a mistake.