FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+ 12. Wheels and tires
- 13. Body
   13.1. Taken care of a body
   -13.2. Monk's hood
      13.2.1. Removal and installation of a monk's hood
      13.2.2. Removal and installation of a thread of a monk's hood
      13.2.3. Removal and installation of the list of monk's hood of isolation
      13.2.4. Removal and installation of a front guard
   +13.3. You carry
   +13.4. Extern elements of a body
   +13.5. Hall elements
   +13.6. System of heating and ventilation
   +13.7. Condicionador
+14. Electric equipment

13.2. Monk's hood

13.2.1. Removal and installation of a monk's hood

ORDER OF REALIZATION

1. To open a monk's hood.
2. Painting to indicate the provision of knots of a monk's hood about a monk's hood.
	3. There unscrew pins (they are specified by firearms) the fastenings of the hinge of a monk's hood.
4. Desconectar to list of isolation of the lowest part of a monk's hood and to withdraw it.
5. Desconectar hoses of lavador of windshield.
6. Desconectar wires of a lamp podkapotny.
7. Through the spectator who considers a monk's hood to unscrew the pins of the knots of a monk's hood.
8. To withdraw a monk's hood. Not to damage the varnished surface of advanced wings, the removal of a monk's hood must be done together.
9. The installation is done in the sequence, the return to the removal.
10. To check and, if necessarily, to adjust the provision of a monk's hood in the horizontal airplane so that the slits in the perimeter of a monk's hood were identic everywhere.
11. The agreement of the provision of a monk's hood in the height is done by the rotation of the emphasis of rubber located in each side at the front of a driving compartment.
	12. For the agreement of the lock of a monk's hood in order that there unscrews a countersow (of 2) of a finger of closure and, when a finger of closure (1) spinning the screwdriver, adjusting the height of the installation of a finger.
13. In the countersow unscrewed the finger of closure it can be mixed in the horizontal airplane and so supply the right fixation of the lock of a monk's hood.