FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car


Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+ 12. Wheels and tires
- 13. Body
   13.1. Taken care of a body
   +13.2. Monk's hood
   +13.3. You carry
   +13.4. Extern elements of a body
   +13.5. Hall elements
   +13.6. System of heating and ventilation
   +13.7. Condicionador
+14. Electric equipment


bfe6b27a


13.1. Taken care of a body
GENERAL INFORMATION

Wash basin bodies

In most of agreements the car prohibits to wash in open sieges, except specially well-adjusted places where the removal of dirty water is executed. Whenever possible urgentemente in order that the dish does the dirty car. Before washing of the car to soak insects and to withdraw of a body surface. To use abundantly the water. To use a gentle sponge or brushes gentle much with the water distribution in a brush. The varnish coverings cannot wash themselves with a current of a strong pressure, to flow of a hose and to take away the dirt while washing of the top I lower it an abundant amount of water. To rinse very often a sponge. To rub pure rags. Only to apply the good detergents desengraxam. It is good to rinse with the clean water of the removal full of detergents. For aims of the protection of a wash basin it is possible to add the washable condoms to the water. In the moment of the regular use of detergents the condoms more very often have to be in use. The car prohibits to wash and to dry in the sun. Otherwise in a varnish surface there will be places. The salt with which the ways spread does dangerous effects on a hoof of the car, therefore, it is necessary more very often to wash itself and carefully the car.

Prevention

After washing of the car because of efficiency of moisture of action of reductions of brakes. It is recommended urgent brakes dry discs of brake in the short term in a departure of the movement.

COVERINGS OF VARNISH

Preservation

Purely the dish did and it dried the varnish that covers necessities to the conservation be prosecuted each of 3 months it means to protect the surface of the car of atmospheric influences for the creation of a layer from waterproof wax without pores.

At the same time to withdraw the spilled fuel, oil or lubricant, and also to curb the fluid, otherwise the color of a covering of varnish will be modified.

The processing of a surface has to happen again if the water is not joined in decreases and if it spreads out in a surface. The regular processing for the conservation ways promotes the long preservation of the lustre of a covering of varnish.

Also there is another possibility of the protection of coverings of varnish – through the washable condoms. Nevertheless the washable condoms supply the protection fiável of coverings of varnish only in case of which they are in use in each one wash themselves of the car and at least, of what during 2-3 weeks.

After the use of the (formation of the foam) washable means what the additional processing of a surface for condoms specially recommends to itself.
Prevention

The preservation cannot be done in the open sun.

Polishing

The polishing of a surface of varnish is only necessary in case of what one faded due to insufficient departure, influence of powder, dangerous gases, conditions of the time, and the conservation ways cannot restore his lustre.

It is not necessary to apply briefcases bruscamente jump and chemically active polishing ways, in spite of originally good results.

Before polishing the car it has of the dish does and to dry carefully. To join besides that to the education of the use of the ways of polishing.

To do small sieges jump to avoid the premature drying of pule. After prosecuting of a surface some polishing it means that it is necessary to do the additional preservation. It is prohibited to polish in the open sun. The conservation and polishing way cannot prosecute the opaque surfaces of varnish.

Removal of places of throw

Fall quickly diffundirut in varnish coverings and it is impossible to withdraw it completely already. The fresh places of the throw can be withdrawn with the gentle rag moistened in the gasoline that blushes. In case of the emergence it is possible to use to usual gasoline, the kerosene or the turpentine. The throw places well are withdrawn through varnish condoms. In this case he will wash of the car one does not need.

Insects removal

The insects contain substances that can damage a movie of varnish if quickly it does not withdraw them. The insects can wash themselves far only the weak lightly hot soap or washable solution or through special ways of the removal of insects.

Removal of solutions of construction

The building materials sneezes are taken away while washing for the lightly hot solution of neutral detergents. Not to be scratched strongly, otherwise it is possible to scratch a covering of varnish. Then carefully to rinse with the clean water.

ARTIFICIAL MATERIALS

Plastic details, which sit down of the imitative leather, a lighthouse, and also it is possible to wash the details painted in the opaque black color with the water with the addition of special detergents. It is not recommended to a wet one. Cleaners can prosecute the plastic details if necessarily special. Not to use nitrosolvent or gasoline in absolute.

Metal adornments wash basin

To rub metal adornments with a pure gentle rag of the internal and exterior side. In the moment of the strong pollution it is possible to use alcohol or liquid ammonia and quiet person, and also special ways of the purification of metal adornments. In a windshield they are sunk to lift clothes to rub of fabric.
Prevention

When it uses silikonosoderzhashchy it means to clean of varnish coverings is impossible to rub with them metal adornments. In the aerosols dispersal silikonosoderzhashchy of glass it is necessary to close a card or other materials.

Taken care of rubber consolidations

Periodicamente to spread the condensation or escorregamento of surfaces with the talcum powder or to sprinkle an aerosol of silicon. It will guard his elasticity and will exclude a scratch when final doors. It is possible to remove unpleasant sounds, having rubbed the next surfaces with the liquid toilet soap.

DISCS OF WHEELS

Discs of wheels of departure of metal demand take, specially in cold station. With this finality it is possible to use special ways to clean of discs. Assets are not applied, acidiferous, silnoshchelochny and rough detergents or water with a temperature any more than +60 °C.

BELTS OF SEAT

The seat belts must wash themselves with the weak alkaline solution, without withdrawing them. Not to subject them to dry the cleaning that can cause the destruction of fibers. To twist belts with the automatic curve in the dried state, if necessary a special aerosol will use for the best escorregamento. It is not recommended to dry belts in a temperature more than 80 °C and in the open sun.

Protection of the bottom and conservation of internal cavities

The whole surface of the bottom is covered of a special protective layer. All the hollow cavities are covered of the resin of the special mastic tree. With the attack of the cold time and after a bottom wash basin the cloth for sheets has to happen and to prosecute the wax besides that protector. Around the action of centrifugal force of powder of wheels, the clay and the sand they can be accumulated. To remove the scums accumulated including the salt, it is extremely necessary, otherwise because of not drying - out of the polluted sieges can appear the corrosion which bodies are not able to prevent a cloth for sheets for much time. For the prevention of the corrosion of an advanced part of the car and driving of mechanisms the driving compartment and the details of the system of brakes and the elements of the direction that are in him will of covered of the wax of conservation of high quality (certainly, after washing itself of the motor).
Prevention

Before washing of the motor in order that a polyethylene movie to close the creator and a tank with the brake fluid. Though the loads of the creator are held tight, nevertheless there is a danger of lixiviar for his additive they dissolve the fat prosecuting. The noise in loads or his failure can be his consequence. During the operation of the car of a little time there can be a smell of the combustion from the wax of conservation in the details that work with the great thermal load. After all the hinges put wax to rub and to polish with the MILLSTONES briefcase.

Taken care of a few articles of tapestry of seats

COVERINGS OF CLOTH

The hoover or a rigid brush clean gentle seats. Session strongly polluted the clear dry foam. To prosecute the fat and the oil notices to gasoline pure or the stain remover. The detergent cannot be poured out straightly in the cloth. The place is withdrawn because of rubbing it in an outline of the edge of a place to the center. Another pollution can be withdrawn, using the water of lightly hot soap.

SEATS FROM LEATHER

In the moment of the long parking straightly in the sun of session and front restrictions it is necessary to cover of the burn. The rags of cloth jersey and wool lightly to a wet one and they rub surfaces from leather so that it does not shear it soaking and sewings. Then to rub the surface dried with gentle rags. The strong pollution can be withdrawn through the detergents refined without lighters (2 tablespoons in 1 l of water). The fat places and of oil they are withdrawn palmadinhas easy through the gasoline pure. The leather when they did the dish that seats it is necessary to prosecute antistatically. Before the use to shake and to put with a fine layer through gentle rags. After drying to be scratched with the pure and gentle cloth. It is recommended each 6 months pass such a processing.