FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+9. Direction
+10. Supports of the triangular form of interruption
+11. Brakes system
+ 12. Wheels and tires
- 13. Body
   13.1. Taken care of a body
   +13.2. Monk's hood
   +13.3. You carry
   +13.4. Extern elements of a body
   +13.5. Hall elements
   -13.6. System of heating and ventilation
      13.6.1. Removal and installation of the unity of control of a heater
      13.6.2. Removal and installation of threads of management of a heater
      13.6.3. Removal and installation of a heater
      13.6.4. To be demolished and meeting of a heater
      13.6.5. Removal and installation of air tubes of a heater
   +13.7. Condicionador
+14. Electric equipment

13.6. System of heating and ventilation

GENERAL INFORMATION

The pure air comes to the hall for a trellis of air entry before a windshield and moves the supporter of heater for the interior of the car. The air passes by a heater and is going through the system of the doors done to work for threads the mouths of the system of heating and ventilation. For the air that heats cold air it passes by a heater electric heater. The electric heater is located in case of a heater and heats the liquid of hot cooling up.

For the increase in a draft the ventilator of three speeds is in use. For the operation of the supporter with several speed when the motor of the supporter is depending on the position of the switch compatívelmente they ballast the joining resistance.

The resistance is located in a supporter's payment. In the moment of the failure of some of the substitution of resistance of the whole payment one needs. The heater and the ventilator are established in the hall below the panel.