| 1. To withdraw a support of brake (to see in top). |
| 2. Desconectar a support of the bearer. |
| 3. To establish a support in a vice. |
| 4. The rotation of the piston in reverse sense to the movement of the pointers of the clock, to unscrew it so that it acted of the cylinder approximately in 20 mm. |
| 5. To withdraw an elastic covering of a flute of piston. |
| 6. To unscrew completely and to take the piston of the cylinder. |
| 7. To take an elastic covering of the piston. |
| 8. The dish does carefully the piston and the cylinder. |
|
9. To take a ring of lock of the piston. |
|
10. To take an axial ring of the piston. |
|
11. To take an undulating lavador and the persistent load of the piston. |
|
12. To take a nut of agreement of the load (it is specified by an arrow). |
| 13. To withdraw a clip to cancel and lavadores of fighter of the piston. |
Prevention
 To observe an agreement of all the retired elements.
|
| 14. To withdraw a ring of fighter of a nut of agreement, to wash out a nut, to polish with the brake fluid a ring of fighter and to establish it at the place in the situation in which it was before the removal. |
|
15. To hold tight a spring of the regulator and to withdraw a ring of lock in a cylinder sleeve. |
|
16. To take a spring covering. |
|
17. To take one spring. |
|
18. To take the placing. |
|
19. Passatizhami with fine sponges to withdraw a ring of lock (it is specified by an arrow) in a sleeve of cylinder (it is specified by an arrow) and to take an empurrador and a formed lavador. |
| 20. To take a support of the brake of emergence of a sleeve of cylinder. |
| 21. To withdraw a repayable spring and a pin of lock of the lever of the brake of emergence. To take the lever and the capture of an end, and also they touch a hunting of a support. |
| 22. To check attentively a condition of all the details. All the scratches or the use follow the trace in the surface of the piston or cylinder of the mean obligation of the substitution of a complete support. |
| 23. In the meeting it is necessary to substitute all the consolidations and to polish component with the brake fluid. |
|
24. 12-006 installs for the adaptation the piston in a rear support. |
| 25. A support adheres to his bearer. |
| 26. To establish and to fix a support in the car (11.2.1 to see the subsection). |
|
27. To install the capture of an end of the brake of emergence (X = 7,5 mm). |
| 28. To withdraw the air of the system of brakes. |
