FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+ 9. Direction
- 10. Supports of the triangular form of interruption
   +10.1. Dispatch the support of the triangular form of interruption
   -10.2. Support of the triangular form of subsequent interruption
      10.2.1. Technical characteristic
      -10.2.2. Service and repair
         10.2.2.1. Substitution of the absorbent one of the shock
         10.2.2.2. Spring substitution of a support of the triangular form of interruption
         10.2.2.3. Removal and installation of the lever of a support of the triangular form of interruption
         10.2.2.4. Substitution of the capture metalrubber of a ray of a rear axle
         10.2.2.5. Removal and installation of the stabilizer
         10.2.2.6. Substitution of loads of wheel
         10.2.2.7. System of agreement of a glimpse of way (eviction)
         10.2.2.8. Removal and installation of the compressor
         10.2.2.9. Substitution of the sensor of height
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

10.2.2.6. Substitution of loads of wheel

GENERAL INFORMATION

Subsequent nave

1 - extern hunting
ring,

2 - extern load,

3 - case of loads,

4 - internal load,

5 - ring of internal fighter

ORDER OF REALIZATION

1. To take away a protective hat of a rear wheel and to weaken nuts of the fixation of a wheel.

2. To weaken a nut of nave in the end of half an end.

Prevention

The nut of the fixation of a nave of the left wheel has the left and right woodcarving – the right woodcarving.

3. To lift and to register a rear part of the car, to withdraw the corresponding wheel.

4. To withdraw the drum of brake.

5. To unscrew a nut of nave in the end of half an end.

6. Through an artist of streaptise with extern captures to withdraw a nave of wheel.

7. To unscrew and to take four pins of the fixation of the case of loads of wheel to the lever of a support of the triangular form of interruption and to take the case of loads of pressure of a rear wheel.

8. To take of the case of loads of wheel two rings of fighter, and also conical loads (extern and internal).

9. A nucleus from the bronze beats extern rings of loads.

10. To compensate for the internal surface of the case of loads of wheel. To install in the case through the adaptation 14,019 extern rings of loads.

11. To polish with the lubricating space between loads and to insert conical loads in the case.

12. To insert in the case hunting touches through the adaptation 14.019.

13. To crush pins of the fixation of the case of loads to the lever of a support of the triangular form of interruption and to hold tight them the corresponding moment.

14. To insert a flange of nave in half an end, to put the placing of half an end and to put the new armband without final pressure.

15. To install the drum of brake.

16. To put a wheel, to put the armbands of the fixation of a wheel and to lower the car.

17. To hold tight the corresponding moment a nut of nave of wheel in the end of half an end and to register it the britamento of a cylindrical part of a nut, a punch from steel in a woodcarving flute.

18. To hold tight the corresponding moment of a nut of the fixation of a wheel.