FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+8. Driving axle and rear bridge
+ 9. Direction
- 10. Supports of the triangular form of interruption
   +10.1. Dispatch the support of the triangular form of interruption
   -10.2. Support of the triangular form of subsequent interruption
      10.2.1. Technical characteristic
      -10.2.2. Service and repair
         10.2.2.1. Substitution of the absorbent one of the shock
         10.2.2.2. Spring substitution of a support of the triangular form of interruption
         10.2.2.3. Removal and installation of the lever of a support of the triangular form of interruption
         10.2.2.4. Substitution of the capture metalrubber of a ray of a rear axle
         10.2.2.5. Removal and installation of the stabilizer
         10.2.2.6. Substitution of loads of wheel
         10.2.2.7. System of agreement of a glimpse of way (eviction)
         10.2.2.8. Removal and installation of the compressor
         10.2.2.9. Substitution of the sensor of height
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

10.2.2.3. Removal and installation of the lever of a support of the triangular form of interruption

ORDER OF REALIZATION

1. To take away a protective hat of a rear wheel and to weaken nuts of the fixation of a wheel.
2. To lift and to register a rear part of the car, to withdraw the corresponding rear wheel.
3. To withdraw a rear pillow of the fixation of the scarf.
4. Desconectar a hose of flexible brake of the oil pipeline of brake and to deaden it the corresponding cork. Desconectar brake tubes of fixing supports of triangular form in the lever.
5. To withdraw the drum of brake.
6. For desconectar a thread of the walk of the parking is curbed by them of fixing supports of triangular form in the lever. To withdraw a thread of the parking they brake of the brake mechanism.
7. To unscrew an end of power of a nave.
8. To withdraw a nave.
9. Desconectar the stabilizer of the angry stability of a torture.
10. To establish a monkey below the lever of a support of the triangular form of interruption and to lift the lever so that the whole load fell in a spring of support of the triangular form of interruption.
	11. The absorbent of the shock unscrews the lowest fixation (it is specified by an arrow).
12. To unscrew from the relevant supporting pins of the fixation of a ray of a rear axle to a body after being bent behind the security placing and unscrewing of a pin of the fixation of the capture of metalrubber, and also two pins of the fixation of a support of this capture to a body.
13. To lower carefully the lever down.
14. To take a spring of support of the triangular form of interruption together with a basic rubber cup.
15. To withdraw the lever of a ray of a rear axle.
16. The installation is done in the sequence, the return to the removal.