FORD'S SCORPIO

1985-1994 of launch

Repair and operation of the car

Ford Skorpio
+1.1. Identification of the car
+2. Maintenance
+3. Motors
+4. System cooling
+5. Fuel system
+6. Union
+7. Transmissions
+ 8. Driving axle and rear bridge
- 9. Direction
   9.1. Technical characteristic
   -9.2. Service and repair
      9.2.1. Removal and installation of directing the transfer
      9.2.2. To be demolished and meeting of directing the transfer
      9.2.3. Removal and installation of a steering-wheel
      9.2.4. To center of a steering-wheel
      9.2.5. Removal and installation of the lock of blockade of a column of direction
      9.2.6. Removal and installation of a column of direction
      9.2.7. To be demolished and meeting of an end of direction
   +9.3. Direction with the hydraulic auxiliary rocket
+10. Supports of the triangular form of interruption
+11. Brakes system
+12. Wheels and tires
+13. Body
+14. Electric equipment

9.2.7. To be demolished and meeting of an end of direction

GENERAL INFORMATION

Regulator of height of installation of a column of direction

Desmontagem

ORDER OF REALIZATION

1. To withdraw a covering of the artificial material of a nave of a steering-wheel.

2. To unscrew a nut of the fixation of a steering-wheel.

3. To introduce a key in the lock of the ignition and to establish it in the situation "I".

4. To withdraw a steering-wheel.

5. To weaken the top that holds tight a pin of agreement.

6. To open by force the regulator, having inserted an edge of the screwdriver between his section e withdrawing the lowest load.

7. To unscrew a pin of case of regulator in 5 mm and to take an end of a column of direction.

8. To withdraw one spring, a lavador and the lowest load of an end.

9. In the lowest part of an end to withdraw the capture from nylon and a spring ring.

10. To withdraw the switch of multiple use.

11. To hold tight a clip and to take a drum of the lock of blockade of a steering-wheel.

12. To unscrew pins of the fixation of the switch of the ignition and to take it together with a braid of electric wires.

13. To withdraw the regulator of the installation of the height of a column of direction. Demolishing the regulator it is necessary to be careful as the spring is in the tension.

14. To hold tight out the superior load of a column of direction.

Meeting

ORDER OF REALIZATION

1. To check a condition of elements of a column of direction. To check if the siege of reduction of an end is covered of oil or lubricant.
	2. An end of a steering-wheel to insist on a vice, decrease of an end establishes in an end the lowest ring from nylon in the distance to 54±1 mm of the face of end more.
3. To install the regulator of the installation of the height of a column of direction.
4. To install the lowest load in the regulator capture.
5. To install the superior load in case of a direction column.
6. To install the switch of the ignition and the switch of multiple use.
7. To establish one spring and a lavador in an end.
8. To insert an end in case of a direction column.
9. To hold tight the screw of the fixation of the regulator of the height of a column of direction.
10. To establish a steering-wheel in the end of an end, to hold tight a nut of the fixation and to establish a covering of the artificial material on a nave of a steering-wheel.